Emergency Lockouts · Glen Grove
Break-In Damage Lock Repair in Glen Grove
Someone smashed the little window beside the door, reached in and turned the thumb-turn. The lock itself is fine, but there is glass on the mat, a hole in the sidelight and a deadbolt anyone can reach.
Call now · open 24/7(289) 275-9650In plain words
A failed break-in is still a repair. When a lock holds against a pry bar or a kick, the force goes somewhere: a strike plate bends, screws loosen, the door edge takes a gouge, the deadbolt binds where the bolt met the strike under load. Left alone, that door locks a little worse each week and the next attempt starts from where the first one finished. The visit checks every part that took the strain, replaces what bent, reinforces the strike and hinges with long screws and confirms the bolt throws cleanly again. It is also the moment to add what would have made the attempt pointless from the start.
How the visit goesSomeone smashed the little window beside the door, reached in and turned the thumb-turn. The lock itself is fine, but there is glass on the mat, a hole in the sidelight and a deadbolt anyone can reach.
Break-In Damage Lock Repair · Glen Grove
How the visit goes
- 1
Does the door still hang true
An impact hard enough to break a strike usually moves the door as well. The locksmith checks that the door sits square in its opening, closes on its weatherstrip without force, and that the bolt lines up with its pocket rather than dragging on the strike lip. Hinge screws are tested for grip, since a kick can pull them from the jamb even on the side that was not attacked, and the hinge leaves are checked for bending. Manufacturers treat strike position, pocket depth and door alignment as working parts of the lock, and a repair that ignores them produces a door that locks badly the day after it was fixed.
- 2
Rekeying what a taken key fits
Every cylinder that a missing key could open is rekeyed or replaced before the locksmith leaves. On a serviceable pin-tumbler cylinder, the plug is slid free with a follower so the springs stay put, the bottom pins are exchanged for a new combination and a fresh key is cut; a cylinder that cannot be rekeyed this way is replaced instead. Front, back, side and garage doors are brought onto one new key where their keyways and systems allow it, and the mailbox and padlocks are handled too. Remotes for a garage opener that left in a stolen car are erased from the opener and a new one programmed. The old key still fits the keyway; it simply turns nothing anymore.
- 3
For tenants and landlords: who holds what
In a rental the repair closes with keys changing hands properly. Provincial tenancy rules place repairs on the landlord and expect a landlord who changes a lock to give the tenant a key, while a tenant changes locks only with the landlord's agreement. So the locksmith notes who authorized the work, how many keys were cut and to whom they were handed, and leaves a copy for both sides. In a condo or apartment building, the superintendent or property manager receives the same note so master key or fob records stay accurate. Everyone ends the day knowing which key opens the repaired door.
In the van
- Grade 1 deadbolt with one-inch throw
- Two-part wood epoxy and shims
- Rekeying pins and key blanks
- Hinge reinforcement plate
- Security strike box
What affects the quote
- 1
Strike and hinge reinforcement
A security strike box, hinge reinforcement plates and three-inch screws on both sides of the door are listed as their own items, so you can see what strengthens the frame beyond replacing what broke.
- 2
Method of jamb repair
Bonding a split with epoxy and a repair plate is one line; fitting a new section of wood is another; a full jamb leg through a carpenter is quoted by that trade.
- 3
Distance to the property
Travel is part of every emergency call, and a property well outside the usual service area involves more driving time, which appears in the quote.
Same fees day, night or weekend.
Break-In Damage Lock Repair: questions
How do I check that the repair is holding over the following months?
Once a month for the first season, throw the deadbolt with the door closed and feel for drag or a stop short of full extension, and press on the strike and hinge screws with a screwdriver to confirm they are snug. Repeat at each change of season, since wood moves with humidity. A door that starts needing a shoulder, or a bolt that catches on the strike lip, wants a small adjustment early rather than a repeat of the original problem.
Do longer screws really make a difference?
A large one. Factory strike and hinge screws are usually short enough to grip only the jamb, a piece of trim about an inch thick. Three-inch screws pass through the jamb and the gap behind it into the stud, so a blow has to move the wall rather than the trim. Lock manufacturers supply reinforcement plates with three-inch screws for exactly this reason, and note that a door beside a sidelight needs a different arrangement because glass sits where the stud would be.
Someone reached through the sidelight to turn the thumb-turn. Should I fit a deadbolt keyed on both sides?
It is tempting, but a thumb-turn lets everyone in the household leave by that door without hunting for a key, special device or special knowledge, so a keyed inside cylinder is the wrong fix. Better answers are a tested security-film system or laminated glass in the sidelight to slow an arm from passing, moving the deadbolt beyond arm's reach of the glass where the door allows, and a glass-break sensor if you have an alarm.
Lockout Services
EmergencyHome Lockout ServiceAfter a week of humid weather the back door has swollen in its frame.
EmergencyBusiness Lockout ServiceA cook stepped into the alley with the recycling and the rear door swung shut behind him.
EmergencyBroken Key ExtractionIn the parking lot your car key snapped in the driver's door.
EmergencySeized & Jammed Lock OpeningIt is the coldest morning of the winter and the key goes halfway into the side door and stops.
EmergencyLost Keys — Same-Visit RekeyThe spare under the planter by the side door is gone.
Break-In Damage Lock Repair near you
Durham, Ontario
Glen Grove information
- Town
- Glen Grove, Durham, Ontario
- In business
- 11 years
- Hours
- Open 24/7 · nights, weekends and holidays, same fees
- Phone
- (289) 275-9650
- Visits
- On-site assessment preferred. Request a visit or call.
What the census means at the door
31%
Newer homes. About 31% of homes in Pickering were built in 1980 or earlier, according to the 2021 Census.
Recent builds often have steel or fibreglass entry doors rather than solid wood. They resist warping and take hardware well, and a locksmith fitting a deadbolt or reinforced strike works with the door's construction so screws bite into something solid.
60%
A mix of homes. Single-detached houses make up about 60% of homes in Pickering (2021 Census).
In areas of mixed housing, landlords may own a house here and a few units there. A locksmith can put all of it under one master system so the owner carries one key while each tenant's key opens only their own door.
Open 24/7
Request a visit
Someone smashed the little window beside the door, reached in and turned the thumb-turn.
Call now · open 24/7(289) 275-9650- On-site assessment preferred
- Same fees day, night or weekend
- 11 years in business